Instruction Manual

M8 Screw x6
M10 Screw x1
7. Combine the speaker with the wall bracket.
8. Confirm the mounting is secure.
INSTALLATION & OPERATION GUIDE
MOUNTING THE BRACKET
CONNECTING THE SPEAKER TO YOUR SYSTEM
1. Remove the screws on the back of the speaker and then remove the waterproof seal cover.
2. The barrier strip terminal block allows for speaker wire input as well as speaker wire output to easily
daisy chain speakers in 70V applications.
3. Determine the locations for the speakers and estimate the length of the additional wire you will need for
each speaker.
4. Connect the speaker wires to (+) and (-) inputs.
5. Select the desired tap setting
6. Replace the seal cover and tighten it.
M10"40 stainless steel screw x2
M10 Elastic medium x2
M10 screw meson x2
waterproof sealing cover x1