Owner`s manual

PureLink by Dtrovision

Installation and Connection Instructions

1. Turn off both the video source and the display before connecting any cables.

2. Connect CAT5 cable between the HCE transmitter and the HCE receiver.

3. Connect HDMI cable between the source and the HCE transmitter AND the HCE

receiver and the display.

4. Connect the power supply unit to both HCE transmitter and receiver module.

5. Turn on Display.

6. Turn on Video Source.

EDID Management

For reliability and correct signal transmission of the video source, EDID emulation is

recommended. Please follow the steps below;

1. Connect the HCE transmitter’s HDMI input port to the display’s HDMI input port.

2. Press and hold EDID button for about 2 seconds until the display’s EDID is

successfully saved on to the transmitter. “EDID PASS” message on the LCD panel

indicates successful EDID save. “EDID ERROR” message indicates failed EDID

save.

3. If you like to read/save other display’s EDID, then repeat the step #1~ #2.

** Please note factory default EDID is based on 1080p. **