User manual

ManualsBrandsPure Link ManualsComputer equipmentFiber Optic Extenders

System Requirements for Setup

 Hardware requirements

 You have to have a DVI graphic controller or card having a DVI

port in your PC, SUN or Mac systems. It should support the

maximum graphic resolution feature of displays to be connected.

 No special requirements for memory size, CPU speed and

chipsets, if you’ve already properly installed your DVI graphic

controllers or cards.

 Software requirements

 No special restrictions, if you’ve already properly installed your

DVI graphic controller in your OS.

 AC/DC Power Adapter Technical Advisory

The transmitter (Tx) module of OLC II is designed for power

protection circuit from conflict of power supply between the external

DC power adapter and your graphic card through the DVI pin. It offers

an option of whether to use an AC/DC power adapter depending on

power supply capability of the graphic card through the +5V pin, you

are using.

However, the receiver (Rx) module should be supplied by an AC/DC

power adapter.

Note 1: In general, most of laptops or desktop PCs with PCI Express

graphic card require using an AC/DC power adapter for the transmitter

module.

Note 2: If you use laptop or Desktop PC with PCI Express graphic card,

we recommend using 5V power adapter for the transmitter.

1-2 System Requirements for Setup

Product Specifications

OLC II Optical DVI Extension Modules

 Compliance with DVI standard: Supports DVI1.0, fully implemented

by fiber-optic communication and DDC2B by virtual DDC.

 Extension limit: 2,000m (6,500feet) for WUXGA (1920x1200) at 60

Hz refresh rate.

Fiber Type

Extension Length at WUXGA

Multi-mode Fiber

500m

Single-mode Fiber

2,000m

 Graphic transmission bandwidth: Supports up to WUXGA at

60Hz, or 1.65Gbps bandwidth per graphic channel.

 Fiber-optic connection: The transmitter and receiver modules of

OLC II have two LC receptacles so as to be connected with one LC

duplex single or multi-mode fibers, having 9(8)/125m or

62.5(50)/125m core.

 DDC connection: Virtual DDC by Auto EDID programming.

 Mechanical specifications of transmitter and receiver modules

 Dimensions: 39mm / 15mm / 69mm (W/H/D)

 Environmental Specifications

 Operating temperature: 0°C to 70°C

 Storage temperature: - 10°C to 85°C

 Humidity: 5% to 85%

AC/DC Power Adapter

 Power Input: AC 100-240V, 50/60Hz 0.1A

 Power Output: +5 V, 2A SMPS DC-power Adapter

 Cord DC Jack: Core is 5 V and outer is GND.

1-7 Product Specifications