Owner`s manual

Troubleshooting
The display displays only black screen.
 Check that all AC and DC plugs and jacks used by external power supplies (both PureLink
and others) are firmly connected.
 Ensure that power bars are live.
 Ensure that the Tx and Rx boxes plug correctly to the media receiver or computer and
display, respectively.
 Check if the media receiver or computer and display are powered on and properly booted.
 Re-boot up the system after reconnecting the optical system cable.
Screen is distorted or displays noises.
 Check if the graphic resolution is properly set. Go to the display properties and tap the
settings. Ensure that the resolution sets less than UXGA (1,600x1,200) at 60Hz refresh
ratio.
 Reset the system.
 Power down, disconnect and reconnect the optical system cable or DC power adaptors,
and power up.
Maintenance
No special maintenance is required for the optical system cables and power supplies. Ensure that
the cables and power modules are stored or used in a benign environment free from liquid or dirt
contamination.
There are no user serviceable parts. Refer all service and repair issues to Dtrovision or its
authorized distributor.
Technical Support and Service
For commercial or general product support, contact your reseller. For technical service, contact
Dtrovision by email [e-mail]