Instructions / Assembly

4pcs
Attention：
Step 1 - Place center bar (3) on a flat service.
Step 2 – Slip the rubber four leg caps (7) onto
each end of the two legs (5).
Step 3 - On each end of the center bar, insert the
legs (5) to raise the center bar slightly off the
flat service. Secure with grip screws (1) at
each end of the hammock, under the center bar
where center bar meets the legs.
Step 4 - Insert hammock support poles (4) into
the inserts from the legs slanted up. Secure with
grip screws (1) at each end of the hammock,
where the hammock supports meet the legs.
Step 5 - Screw the hammock hooks (2) into each
of the top hammock support poles (4) , with the
hooks on the outside of the assembly facing
down as pictured.
Step 6 – Place the end ropes of one end of the
hammock bed (6) over the U bar of the hammock
support pole (4) and then over the hammock
hook(2). Stretch the other end rope over the other
U bar and over the hook on the opposite end
of the assembly.
How to assemble: