Owner Manual

GQBrands.com [e-mail] 1-866-498-5269
ASSEMBLY INSTRUCTIONS
8
STEP 4
STEP 5
Parts:
Part 2 (x2) - Foam Rocker Bar
Part 7 (x4) - M6 45mm Bolt
Part 11 (x4) - Hex nut
Part 12 (x4) - Washer
NOTE: Round Cap (Part 16) is already
installed on the Foam Rocker Bar
(Part 12). If not, slide to both ends and
make sure the tub ends are covered
Place the Foam Rocker Bars (Part 2)
on the outside of the Base Rails facing
away from the Seats.
Align the opening of the tip of the
Base Rails to the opening under the
Round Cap of the Foam Rocker Bars.
Tighten with a M6 45mm Bolt (Part
7), Hex Nut (Part 11), and Washer
(Part 12).
2
2
11
12
7
Inside the Foam Rocker Bars, there
are 8 indent locations as shown. You
can find them when pressed.
Once you have found the indent, using
a sharp Knife, cut a slit in that location
to reveal the opening on the Bar itself.
WARNING!
Cutting the slits on the Foam Rocker
Bar must be done by an adult
(+18 Years). For more information,
review The Warning and Safety
instructions on Page 5.