Owner Manual

8
[e-mail]
1-866-498-5269
ASSEMBLY INSTRUCTIONS
2
STEP 1:
Lay the 2x Base Rails (Part 1) side by side
and place 1x Seat (Part 6) in between these
rails. It is recommended that you start from
the center of the rails, as shown.
Place 4x Square Nuts (Part 10) into the
slots in the underside of the Seat. Next,
keeping the holes directly opposite these
nuts lined up to the holes in the Base Rails,
hold each Square Nut in place with your
finger (or a pair of needle nose pliers) and
thread 4x M6*1.375” (Part 8) Bolts through
the rails and into the square nuts
Ensure that the square nut does not spin
while you begin to tighten this connection.
NOTE:
Do not fully tighten these until all seats are
in place.
Repeat the above steps for the remaining
4x Seats, but DO NOT place bolts where
the “X” marks are displayed in the below
diagram (the end holes on the seats).
STEP 2:
Locate the 2x Handle Tubes (Part 3) and the
2x Footrest Tubes (Part 5).
Gently flex the Handrails so that the screw
holes in the Footrest Tubes line up to the
corresponding holes in the Handles.
Attach with 4x M6*1.5” Screws (Part 8A)
and 4x Hex Nuts (Part 11). Once tightened,
cover the exposed bolt ends with 4x Safety
Caps (Part 13).
1
X
X
X
X