Instructions / Assembly

FREQUENTLY ASKED QUESTIONS
Question: “How should I clean my
seesaw?”
Answer: you should clean the
Seesaw with a solution of warm
water and Non- Corrosive/Abrasive
soap. Dampen a rag with this solution
and wipe completely dry before
using.
Question: “A seat seems loose,
what should I do?”
Answer: Make sure the Bolts/Nuts
under the plastic seat are secure.
Question: “Something was missing
from the packaging,” “I need to
purchase a replacement part” or “I
discovered a damaged piece. What
should I do?”
Answer: Contact customer service.
You must have proof of purchase
and/or order confirmation available to
be considered for warranty
replacement. You must report
missing pieces within 30 days of
purchase.
GQBrands.com [e-mail] 1-866-498-5269
12
CARE & MAINTENANCE
• Before each use of this product, inspect the entire assembly
and replace any worn, defective or missing parts.
• The following conditions could represent potential hazards:
Missing, improperly positioned, or insecurely attached seats; A
bent or broken frame; Cracked or broken seats. Cease using
seesaw immediately and secure it against unauthorized use if
any of these conditions are present.
• Regularly check to see if the steel tubes, seats, backrests and
other parts are tightened and completely secure. Replace worn
& damaged parts if found and if necessary, secure from use
until replacement parts can be obtained.
• If the paint is chipped, we recommend you lightly rub the
damaged area and cover using a non-toxic enamel paint.
• High touch surfaces made of plastic or metal, such as grab
bars and railings should be cleaned routinely.
• Do NOT use bleach as it may cause colors to fade.
• Use wet towel or cloth with mild soap and water solution to
wipe down metal parts, seats and handlebar. Dry
Immediately and do not allow children to use until
completely dry.
• To disinfect surfaces - use a 70% / 30% Rubbing Alcohol
to Water mix to clean seat and handlebar surfaces. The
surface must remain visibly wet for at least 4 minutes,
allowing it to dry on its own. After 4 minutes, the surface
may be rinsed thoroughly and wiped dry to eliminate water
marks. This solution will lose its effectiveness in about 24
hours, so a new batch must be made each day.
Thank You Coupon!
As a way of saying thank you for purchasing one of our products, here is a 10% OFF coupon for
your next purchase at
www.PureFun.net
Use Code: GQBRANDS10 at Checkout
Cleaning your Playground Equipment