6 FT KIDS WAVY SLIDE MODEL# 9305WS PRODUCT MANUAL - VERSION 03.16.02 FOR AGES: 4-10 WEIGHT LIMIT: 75 Lbs 34 Kgs ADULT(S) NEEDED: TOOLS NEEDED: WARNING/ADVERTENCIA • ADULT ASSEMBLY REQUIRED. • Do not allow more than one person on this product at any time. • Adult supervision is required. • Please read all the instructions before using this product. CUSTOMER SERVICE • Consult a physician before beginning any exercise program or strenuous activity.
CUSTOMER SERVICE INFORMATION Thank you for purchasing: 6 FT KIDS WAVY SLIDE MODEL# 9305WS At Global Quality Brands®, we want all of our customers to be completely satisfied with their purchase. Please take time to review the contents of the product you have just received to make sure that all of the parts are included. If you find that any parts are missing or damaged, we will happily provide replacement parts at no charge within 30 days of purchase.
LIMITED WARRANTY Global Quality Brands® warrants this product to be free from defects in workmanship and materials under normal use and conditions for a period of 90 DAYS FROM THE DATE OF ORIGINAL PURCHASE. This Limited Warranty is not transferable and is available only for the original purchaser of the Product. The Company’s obligation under this warranty is limited to replacing or repairing the Product, at the discretion of the company.
WARNINGS IMPORTANT MESSAGE WARNING - PLEASE READ ADULT ASSEMBLY REQUIRED CHOKING HAZARD - Small Parts NOT for children under 3 years of age. WARNING: While every attempt is made to ensure the highest degree of protection in all equipment, we cannot guarantee freedom from injury. The user assumes all risks of injury due to use. All merchandise is sold on this condition, which no representative of the company can waive or change. 4 GQBrands.com CustomerService@GQBrands.
WARNINGS Please read these warnings and the information in this manual in its entirety. Failure to comply with the following instructions may increase the risk of serious injury and/or death: • This unit must be assembled and disassembled by ADULTS ONLY. • This Wavy Slide is suitable for use by most children 4 to 10 years of age. • Never use this product in any manner other than its intended use. • DO NOT exceed the maximum weight limit of 75lbs (34kgs) regardless of age.
ASSEMBLY WARNINGS • When you are ready to start, make sure that you have the correct tools at hand, and adequate space for assembly. Please refer to the table for part descriptions and numbers. The assembly instruction uses these descriptions and numbers as reference. Make sure you have all parts listed.
PARTS LIST Part # Description QTY Part# Description QTY A PM6 30mm Bolt x1 K Base Tie Bar (Chute) x1 B M6 35mm Bolt x5 L Hand Rail Tubes x4 C M6 25mm Bolt x1 N Spanner Wrench x1 D M6 Washer x7 O Ground Anchor x2 E Spring Washer x7 P Chute Base Tube x1 F Dome Nut x7 R End Caps x4 G Base Tie Bar (Ladder) x1 S 40mm Step Bolt x6 H Ladder Step x3 T 15mm Bolt x2 I Ladder Stabilizer x1 U M6 Square Washer x7 J Slide Chute x1 - - - A I N B J P C
ASSEMBLY INSTRUCTIONS STEP 1: A A. Insert a M6 Square Washer (S) into each slotted receptacle in the bottom of the 3x Ladder Steps (H) B. Assemble the steps to the Lower Handrail Tubes (L). NOTE: During this assembly step, ensure that the Ladder Steps (H) are oriented correctly, so they will be horizontal when the ladder is assembled. See below diagram before continuing: B FACES OUTSIDE C.
ASSEMBLY INSTRUCTIONS STEP 2: Attach the Ladder Stabilizer Bar (I) to the lower ends of each Handrail Tube (L) as shown below. NOTE: Ensure all bolts are fully tightened and flush to the tubing before continuing. STEP 3: A. Place the Slide Chute (J) onto the Assembled Ladder Frame by angling the Handrail Tube tops so the chute will slide onto the Ladder frame. Slowly push the Slide Chute (J) down while raising the frame bottom until the Chute is completely on the Ladder Frame. B.
ASSEMBLY INSTRUCTIONS STEP 4: A A. Secure the Tie Bars together using 1x 25mm Bolt (C), 1x Washer (D), 1x Spring Washer, and 1x Dome Nut (F). Tie Bar (Chute) K Tie Bar (Ladder) G B. Attach the Base Tie Bar (Chute) (K), to the Chute Bottom Support Tube (P) using 1x 30mm Bolt (A), 1x Washer (D), 1x Spring Washer (E), and 1x Dome Nut (F). C. Next, attach the Base Tie Bar (Ladder) (G), to the Ladder Stabilizer Bar (I) using 1x 35mm Bolt (B), 1x Washer (D), 1x Spring Washer (E), and 1x Dome Nut (F).
ASSEMBLY INSTRUCTIONS 5 STEP 5: Slide the Assembled Chute Bottom Support Tube (P) / Base Tie Bar (Chute) (K) up into the bottom of the Slide Chute (J), so the holes in the ends of the tube are lined up to the holes in the chute. Secure this assembly with the 2x 15mm Bolts (T). NOTE: Ensure all bolts are fully tightened and flush to the tubing before continuing. 6 STEP 6: Before placing your slide in the play area, please ensure you read the section on the following page.
CARE & MAINTENANCE • If any part of the slide requires cleaning, simply wipe with a damp cloth. • Regularly check to see if slide chute, steel tubes, steps, ground anchors and other parts are tightened and completely secure. • Replace worn & damaged parts when if found and if necessary, secure from use until replacement parts can be obtained. • If the paint is chipped, we recommend you lightly rub the damaged area and cover using a non-toxic enamel paint.
