Exploded Diagram

ManualsBrandsPure Energy ManualsPaintballThor

THOR

SECOND STAGE REGULATOR

The THOR is a High Performance Second Stage Regulator that has been specifically

designed to operate in conjunction with a preset primary regulator. This combination of a

Preset Primary and an Adjustable Secondary provides the consistent, unvarying gas

pressure and high flow demanded by the Pro Level Player.

INSTALLATION

The installation of the THOR is similar to the physical installation of any

“Bottom Line” type of N2/HPA system. The THOR mounts using a

standard dovetail mount, and the first step is to attach the mounting rail

to the airgun. The basic mounting rail assumes the standard two hole

pattern which uses two 10-32 threaded holes, spaced 3/4” on center. If

your airgun does not have this bolt pattern, contact your local store or

airsmith for the proper adapter. The THOR is also compatible with any

of the aftermarket mounting systems that offer the standard dovetail

mount.

Once the mounting rail has been mounted, the

THOR can be secured to the rail. Once the

desired position is found, the THOR is locked in

position using a 3/32” Allen wrench in the set

screw in the mounting rail, as shown on the right.

Now is also the best time to make your gas

connections to the airgun. The THOR has two

1/8 NPT output ports, so you can set up your

output connection and output pressure gauge for

either right or left hand orientation. If you are not

using quick disconnects, it will be much easier to

thread all hoses and fittings into place before

sliding the THOR onto the mounting rail. Now is also a good time to check your Preset Regulator’s gauge and fitting

orientation. Gauge and Fill Fitting position will vary from Preset to Preset, once they are screwed into the THOR, and this

may affect your final positioning of the system on the mounting rail.

15 Jan. 2003

Summary of content (4 pages)

PAGE 1
THOR SECOND STAGE REGULATOR The THOR is a High Performance Second Stage Regulator that has been specifically designed to operate in conjunction with a preset primary regulator. This combination of a Preset Primary and an Adjustable Secondary provides the consistent, unvarying gas pressure and high flow demanded by the Pro Level Player. INSTALLATION The installation of the THOR is similar to the physical installation of any “Bottom Line” type of N2/HPA system.
PAGE 2
ADJUSTING THE THOR’S OUTPUT PRESSURE The output pressure is adjusted by inserting a 1/8” Allen wrench into the front of the regulator and turning. Turning the wrench clockwise will increase the output pressure, and turning it counterclockwise will decrease the pressure. When turning the pressure down, always remember to cycle the airgun as you make the adjustment. This releases the gas trapped in hose and fittings, so that you can get an accurate pressure indication.
PAGE 3
TO DISASSEMBLE 1) 2) 3) 4) 5) 6) Remove the four allen screws that hold the Bonnet to the Main Body. Remove the Bonnet, Main Spring, and the Spring Shim. Grasp the piston, and pull. The entire internal part set should come out of the Main Body. Slide the Teflon Reg Seal off over the end of the Regulator Valve Pin. Pull the Piston & Regulator Valve Pin assembly out of the insert. Screw the Regulator Valve Pin out of the Piston. You have now completely disassembled your THOR.
PAGE 4
TOP PERFORMANCE: The combination of a Preset Primary Regulator and the THOR gives the Pro Level player true dual stage regulation. Response curve caused velocity variations are a thing of the past. With the THOR, if you walk on to the field shooting 295 FPS, you can be sure you will walk off with the same 295. SAFETY SYSTEM: The THOR incorporates a positive safety system that makes use of the normal travel of the sensor piston.