User Manual

Our Address
Puravent, Adremit Limited, Unit 5a, Commercial Yard,
Settle, North Yorkshire, BD24 9RH
Get In Touch
Call: 0845 6880112
Email: info@adremit.co.uk
Page 7 of 10
MAINTENANCE
Cleaning
ATTENTION: Please shut off the unit and unplug from the mains before
cleaning or performing any maintenance.
Cleaning the surface
Clean the plastic housing with a duster or a soft wet cloth.
Do not use chemical solvents (such as benzene, alcohol or gasoline) as they may cause
irreversible damage. Make sure no water enters the control panel.
Cleaning the water tank
Unplug the power cord then remove the water tank. With a cloth
(dipped in a mild detergent), wipe the water tank, rinse it with
water, and then carefully place it back in the unit.
Draining the water reservoir and refilling with fresh water at least
once a week will help reduce any mineral deposits and keep the
filters clean.
Do not run the unit in Humidify mode with stale water in the tank.
We recommend emptying the tank and refilling it with fresh
water if water has been standing in the tank for an extended
period of time.
MAINTAINING AND CHANGING THE HONEYCOMB
FILTER PADS
The appliance is supplied with a set of 3
honeycomb cooling / filters pads (back and
sides). The cleaning frequency for the
honeycomb filter depends on local air and water
conditions. In areas where the mineral content of
water is high (hard water), mineral deposits may
build up on the honeycomb cooling filter and
restrict air flow. If mineral deposits remain on the
honeycomb pads, the filter should be removed
and washed under fresh water. We recommend
cleaning the honeycomb filter at least every two
months, depending on your needs.
For best results, allow the honeycomb filter to
dry after each use by turning off the humidify
function for 15 minutes (with empty water tank)
before turning the unit off.
Unplug the power cord, then remove the honeycomb filter
frame, and take the honeycomb filter out of the bracket. With a mild detergent and a soft
brush, scrub the honeycomb filter, clean with water and dry. Do not dip in water.
End of Season Maintenance
1. Empty the tank and wash it with warm soapy water.
2. Dry the tank and clean the Honeycomb pads
3. Store any Icepack you may use in the water tank
4. Cover the unit and keep it in a dry place.