User Manual

Our Address
Puravent, Adremit Limited, Unit 5a, Commercial Yard,
Settle, North Yorkshire, BD24 9RH
Get In Touch
Call: 0845 6880112
Email: [e-mail]
Page 6 of 10
INSTALLATION
This unit can easily be moved from one room to another. While moving the unit please note
that it must always be kept upright and then placed on an even surface.
• Remove any packaging - keeping the air cooler in a vertical position.
• Make sure all parts are present and unit is assembled correctly - including the castor
wheels (these need to be pushed into place on the base of the unit)
• Water tank: Fill the water tank with water or ice ensuring it does not to go above the
MAX level visible in front of the unit. A direct hose feed can be used to keep the water
tank topped up. The hose can be connected using the hose connector.
• Make sure filter pad is properly inserted at the back of the unit.
• Connect the power plug to a working socket, and then press the power button.
Note: If you want to remove the water tank, please pull out after unit has been
powered-off for 2 minutes.
CONTROL PANEL AND SETTINGS
ElectrIQ Arctic Control Panel
• Cooler ON / OFF: Turn the knob to the ON position to turn the unit on and start the cooling
function. Turn the knob to the OFF position to turn the unit off and stop the cooling function.
• Speed OFF / LOW / MID / High: Turn the knob to LOW, MID or HIGH to set the fan to the
desired speed.
• Swing OFF / ON: Turn the knob to the ON position to turn on the fan swing function. This will
allow the air to circulate more around the room. Turn the knob to the OFF position to turn off the
fan swing function. This will give a more constant stream of cool air similar to natural breeze.
Water Filling
Before turning on the cooling and humidification function, please add water to the tank.
You can use the unit without water in air cleaner mode only. There are two methods –
Automatic and Manual.
Automatic Filling
- connect the device to an outlet with a piece of hose
and then turn on the outlet.
Manual Filling - b
efore filling with water, open the water
inlet, fill the water tank slowly and then
return the water inlet into the original
position. Only use clean tap water and
do not fill the water beyond the maximum
water level
← Arctic-Plus Arctic
→
Note:
It is completely normal and in no way dangerous if the device has a slight odour
or the water tank has a slight discolouration when it is used for the first time.