Instructions / Assembly

© PumpSpy Technology, LLC Questions? Email Tech Support: [e-mail]
WARNING! Turn power to main pump off!
WARNING! Electric shock hazard. DISCONNECT power before servicing.
• Verify that the existing AC pump is in good working order. If the AC pump is questionable, replace.
• Remove any debris from the sump pit and surrounding area.
UNPACKING
Inspect this unit before beginning installation. Occasionally, products are damaged during shipment. If any
components are damaged, contact PumpSpy
™
at [e-mail] for replacement.
DISCONNECT YOUR WAYNE BACKUP PUMP
1. Unplug your main sump pump (and switch assembly, if applicable) from AC power.
2. Unplug your Basement Watchdog backup pump control box from AC Power
3. Disconnect the Basement Watchdog backup pump and switch from the control box.
4. Open the battery case and disconnect battery.
5. Open the sump pit and remove the Basement Watchdog backup pump switch.
6. Dispose of the Basement Watchdog battery case, AC adapter, float switch and electronic control box.
INSTALLATION
WARNING
The PumpSpy System requires a 12V Deep Cycle Battery with a minimum 40 AMP/HR
rating, 75 AMP/HR rating (or higher) recommended. AGM Battery is strongly recommended.
BEFORE DISCONNECTING PUMPS AND
CONNECTING THE PUMPSPY PS2000 SYSTEM