Specifications

Maintenance
48 Version 2011v1
3.10.3 Replacing flashing light (front)
• See fig. 020710030.
Flashing lights should be replaced as follows:
• Manually turn the reflector (A) a bit to the left.
• Pull the reflector from the holder (B).
The reflector is attached to the holder with a bayonet
closure.
• Loosen the two crosshead screws (C).
• Remove the cover (D).
• Loosen the two screws (E) of the reflector (F) with a
screwdriver with a width of 5 mm.
• Pull the bulb (G) from the holder.
A new bulb should be replaced in the reverse order.
For the proper type of bulb, see 'bulb overview'.
EBAYES-020710030-en.doc
3.10.4 Replacing flashing light (rear)
• See fig. 020710040.
A rear flashing light should be replaced as follows:
• Loosen the two screws (A) of the reflector (B) with a
screwdriver with a width of 5 mm.
• Pull the bulb (C) from the holder.
A new bulb should be replaced in the reverse order.
For the proper type of bulb, see 'bulb overview'.
EBAYES-020710040-en.doc
3.11 Cleaning
Removing dry dirt
Upholstery, metal parts and frame parts can usually be cleaned easily with a dry soft cloth.
Removing mud and/or other wet dirt
Parts that are soiled with wet dirt can best be cleaned by first wiping the dirty parts with a damp cloth and then
wiping them dry with a dry soft cloth.
Upholstery
Cleaning with a damp cloth and household soap. After removing the dirt the cleaned parts should be wiped dry with
a soft dry cloth.
• Never use abrasive or aggressive cleansers. They can damage the wheelchair.
• Also do not use organic solvents such as thinner, washing benzene or turpentine.
• Be careful with water in connection with the electronic system.
• Upholstery: do not dry clean, iron or spin dry.
EBAXXX-010704000-en.doc
G
F
B
A C D E
020710030
A
C
B
020710040