Specifications

Maintenance
38 Version 2011v1
3.7.3 Replacing the LM / CLAM module
• See fig. 020708030.
The module should be replaced as follows:
• Remove the cover from the battery tray and the rear
cover. See ‘mounting and removing the covers’.
• Pull the connectors (B and C) from the module.
• Slide the module (A) up and off the holder.
• A new module should be placed in reverse order.
Attention:
• Never replace a LM module before a
CLAM module and vice versa.
EBAPUM-020708030-nl.doc
3.7.4 Hand programming unit 'DX'
• See fig. 020903010.
If the electric wheelchairs have a dynamic 'DX' drive, they all
have a programming contact (A) in the controller. The plug of
the programming module goes in here. This plug can be
removed or put in at any time; this does not harm the
program or the drive. The programming module starts up
immediately if the drive is switched on.
It is possible that if the programming module is connected
and the controller is switched on, an 'accessory fault' may be
signaled. This fault signal can be ignored.
But if the control is switched on and then the programming
unit is connected and then there is a signal, this is a real fault
signal.
The four driving programs and the accompanier's drive
(driving program 6) can all be separately set on
10 parameters. As a standard only the speed parameters are
different, but experts are free to coordinate the other parameters to the individual wheelchair user.
Use the flowchart diagramming to program.
Changing the driving settings is entirely the responsibility of the individual: Handicare cannot be
held liable for (inexpert) use of the HHP unit.
Have adjustments done solely by experts.
EBAXXX-020903010-en.doc
C B
A
020708030
PROGRAMMEE
DYNAMIC
020903010
A
DX