Specifications

Maintenance
Version 2011v1 37
3.7.1 Replacing the controller 'DX'
• See fig. 020708010.
Before doing any work, switch off the
automatic safety fuse by pushing the button
on the side of the wheelchair.
The controller 'DX' should be assembled as follows:
• Pull the plug (A) from the controller, by pushing in
the lock (B) and simultaneously pulling the plug from
the controller.
• Loosen both screws (C) and the rings with a Phillips
screwdriver PH-2.
• The controller 'DX' (D) can now be removed.
Attention:
• The controller must be programmed for
this type of wheelchair.
A (new) controller should be assembled in reverse order.
After assembly push the button of the automatic fuse in: the wheelchair is now ready to operate.
EBAXXX-020708010-en.doc
3.7.2 Replacing the power module 'DX'
• See fig. 020708020.
Before doing any work, switch off the
automatic safety fuse by pushing the button
on the side of the wheelchair.
The power module 'DX' should be replaced as follows:
• Remove the cover from the battery tray and the rear
cover. See ‘mounting and removing the covers’.
• Slide the protective cover (A) up and away from the
power module ‘DX’ (D).
• Pull the connectors (C) from the power module 'DX'.
• Loosen both Allen bolts (B) using an Allen key with a
key width of 4 mm.
• Remove the power module 'DX'.
• Turn the controller on and off again to prepare the
wheelchair for operation.
A (new) power module ‘DX’ should be assembled in reverse
order.
After assembly push the button of the automatic fuse in: the wheelchair is now ready to operate.
EBAPUM-020708020-nl.doc
B
C
AD
020708010
D
C
A
B
020708020