Specifications

Adjustment options
22 Version 2011v1
• Take away the supports from under the chair and lower the chair to the ground.
• Securely tighten both nuts again.
EBAPUM-010508020.nl.doc
2.7 Adjusting the height of the side panel
• See fig. 010509010.
The side panels should provide sufficient support and
sufficient freedom of movement so that you can assume a
comfortable position in the chair.
The side panels can be adjusted in height.
• The height adjustment can be done as follows:
• Flip off the studs from the inside of the side panel.
• Loosen both crosshead screws (A) a couple of twists,
using a Phillips screwdriver PH 2. Keep the nuts from
turning by holding them on the inside with a socket
wrench with a key width of 8 mm.
• Slide the side panel (B) at the desired height.
• Tighten the crosshead screws securely again.
• Replace the studs.
EBAPUM-010509010.nl.doc
2.8 Adjusting the headrest (option)
• See fig. 010510000.
A headrest can be attached to the back of the backrest.
The headrest can be adjusted in:
A. Height.
B. Depth.
C. Angle.
XXXXXX-010510000.en.doc
B
A
010509010
A
C
B
010510000