Specifications

Adjustment options
Version 2011v1 21
2.6 Adjusting the armrest
• See fig. 010508000.
The armrests provide support to the arms to limit the burden
on the shoulders. For this purpose the armrests can be
adjusted in terms of height (A) and depth (B).
The armrests can also be removed (C), to make space to
leave the wheelchair sideways, for example if you make a
transfer from a car seat.
By removing the armrests the wheelchair can be made
smaller, which and it simplifies transport.
EBAPUM-010508000.nl.doc
2.6.1 Adjusting the height of the armrest
• See fig. 010508010.
The height adjustment can be done as follows:
• Loosen set bolt (A) with an Allen key with a key width
of
4 mm.
• Slide the armrest (B) to the desired height.
Make sure that the arms are well supported,
without the shoulders being pushed upward.
• Tighten the setscrew again.
EBAPUM-010508010.nl.doc
2.6.2 Adjusting the depth of the armrest
• See fig. 010508020.
To adjust the depth of the armrest, the chair should be raised
in order to be able to reach the depth-adjustment screws.
The chair should be raised as follows (you have to leave the
chair first):
Using a 13 mm spanner, loosen the nuts (A) a number of
turns in order to raise the chair sufficiently to be able to
loosen the Allen bolts (B).
Now, you can adjust the depth of the armrests.
Make sure the chair is supported by a
wooden block or something similarly strong,
so that the chair cannot come down and
risking someone’s fingers from getting
jammed underneath.
The depth adjustment of the armrests should be done as follows:
• Loosen the Allen bolts (B) on both sides of the chair with an Allen key with a key width of 4 mm.
• Slide the armrests (C) in the desired position.
• Tighten the Allen bolts again.
Note that the adjustment is carried out equally on the left and the right side.
C
A
B
010508000
B
A
010508010
B CA
010508020