Specifications

Adjustment options
16 Version 2011v1
2.2.4 Adjusting the seat angle
• See fig. 010502040.
The seat part of your wheelchair can be set at an angle that is
comfortable for you. In this adjustment the angle of the entire
chair is tilted with respect to the bottom part of the chair.
Before adjusting the seat angle you must leave the chair.
The seat angle must be adjusted as follows:
• Loosen nuts (A) on both sides with a spanner with a
key width of 13 mm.
• Adjust the new angle by turning the nuts (B) up or
down.
See to it that the nuts (A) are turned sufficiently far
down so that the height can be set without any
problems.
For each degree that the seat is set
backward the seat height rises approximately
5 mm (1/4").
• Tighten the nuts in the position finger-tight.
• Try the new position.
• Lock the new seat angle by tightening the nuts on both sides securely against each other.
EBAPUM-010502040-en.doc
2.2.5 Position of seat cushion
• See fig. 010502050.
The seat cushion can be fastened to the frame in three
positions. This allows the seat depth to be reduced.
The location of the seat cushion can be changed as follows:
• Remove the seat from the chair by pulling it up.
• Loosen the two clamps (B) with a Phillips screwdriver
PH2.
• Place the clamps at one of the other places (A).
• Place the seat on the chair by clicking the clamps on
the front round tube of the seat frame.
Check whether the seat is clicked in place
securely.
XXXXXX-010502050.en.doc
B
A
010502040
B
A
010502050