2V Digital Battery Analyzer Tester & Printer 490PT+ Tests 12V Batteries and Charging Systems
TEST PROCEDURES / OPERATING INSTRUCTIONS IMPORTANT： 1. For testing 12 volt battery. 2. Suggested operation range 32℉(0℃) to 122℉(50℃) in ambient temperature. Printer Paper Negative Clamp (BLACK, - ) Clear Cover LCD Display UP/DOWN Button Positive Clamp (RED, + ) www.pulsetech.
WARNING: 1. Working in the vicinity of a lead acid battery is dangerous. Batteries generate explosive gases during normal battery operation. For this reason, it is of utmost importance, if you have any doubt, that each time before using your tester, please read these instructions very carefully. 2. To reduce risk of battery explosion, follow these instruc -tions and those published by the battery manufacturer and manufacturer of any equipment you intend to use in the vicinity of the battery.
to weld a ring or the like to metal causing a severe burn. PREPARING TO TEST： 1. Be sure area around battery is well ventilated while battery is being tested. 2. Clean battery terminals. Be careful to keep corrosion from coming in contact with eyes. 3. Inspect the battery for cracked or broken case or cover. If battery is damaged, do not use tester. 4. If the battery is not sealed maintenance free, add distilled water in each cell until battery acid reaches level specified by the manufacturer.
3. Make sure the battery terminals are clean. Wire brush them if necessary. Clamp the black load lead to the vehicle negative battery terminal. Clamp the red load lead to the vehicle positive battery terminal. Place the clamp on the terminal. 4. Paper load: Open the clear cover. Insert paper to the paper feeding for auto running the paper into printer. STEP 1: Connect the clamps to the tested battery. STEP 2: Open the clear cover STEP 3: Insert the paper roll 57MM(W)X30M(L) Part No.
5. You will view the following screens: Testing Cont. SYSTEM ANALYZER BATTERY VOLTS XX.XX V Press ''Enter" to do battery test. SYSTEM ANALYZER BATTERY TEST XX.XX V SYSTEM TEST XX.XX V www.pulsetech.net Press ''UP/DOWN'' to select battery or system test. Press ''Enter" to do system test.
6. Press the ''UP/DOWN'' key to select battery test. Press "ENTER" button. 7. Press the ''UP/DOWN'' key to select the battery type: a. FLOODED CELL b. AGM FLAT PLATE c. AGM SPIRAL d. GEL BATTERY TYPE AGM FLAT PLATE Press "ENTER" to confirm choice. 8. Press the ''UP/DOWN'' key to input the battery capacity of CCA. Press "ENTER" to begin the test. SET CAPACITY XXXX CCA 9. Press the ''UP/DOWN'' key to select battery fully charged or not if tester asks. Press "ENTER" to confirm choice.
10. When the test is completed, the display shows the actual volts and the actual CCA or %. {Press the ''UP/DOWN'' key to select SOH (STATE OF HEALTH) or SOC (STATE OF CHARGE)}. One of three results will be displayed: GOOD & PASS : The battery is good & capable of holding a charge. GOOD & CHARGE : The battery is good but needs to be recharged. CHARGE & RETEST : Battery is discharged, the battery condition cannot be determined until it is fully charged. Recharge & retest the battery. GOOD & PASS XX.
PULSETECH PRODUCTS CORPORATION 1-Year Limited Warranty What Does This Warranty Cover? This warranty covers any defects in workmanship or materials in the product under normal use and service. How Long Does The Coverage Last? This warranty runs for one (1) year from the date of purchase. What Will PulseTech Do? PulseTech will, at its option, repair the unit or replace the unit with a remanufactured unit at no charge.
