2 CHANNEL, CLASS D AMPLIFIERS PA2X25 PA2X60 PA2X125 PA2X150 pulseaudio1.com | vanco1.com | 800.626.
DEAR CUSTOMER Thank you for purchasing this product. For optimum performance and safety, please read these instructions carefully before connecting, operating or adjusting this product. Please keep this manual for future reference. THIS PRODUCT IS 100% INSPECTED AND TESTED IN THE UNITED STATES TO VERIFY PERFORMANCE PARAMETERS. WARNING 1. Do not install or place this unit in a built-in cabinet, or other confined space without adequate ventilation. 2.
FEATURES The PA2X amplifier series from PulseAudio are an ideal solution for residential and commercial audio installations that require a simple setup and great sound output. With a small footprint, but high output, these Class D amplifiers can sit on a desktop, or can easily be mounted on a wall or within a rack using the included mounting brackets. The amps can be used in a stereo system, but can also be switched for use in bridged or mono applications.
PANEL DESCRIPTIONS 2a 3a 3b 1 3 5 2 2b 4 1. MODE selection between Stereo, Mono, or Bridge 2. Connection to speakers using the included phoenix connector • For stereo operation, connect the Left and Right speaker wires to the corresponding terminals • For bridge-mono operation, connect the positive speaker wire to the L+ and the negative speaker wire to the R+ terminals 3. Connect a source device to the INPUT terminals - 3.5 or RCA* • 3.5mm connection • RCA connection 4.
CONNECT AND OPERATE 1. Connect an audio source to either the 3.5mm or the dual-RCA inputs 2. Connect the speaker wires to the provided green phoenix connector, ensuring the negative port on the amp is going to the negative terminal on the speaker(s), and the positive port on the amp is going to the positive terminal on the speaker(s). 3. Use the MODE switch to select the correct configuration a. For Stereo mode, all ports on the phoenix connector will be used b.
SPECIFICATIONS Model Number: PA2X25 PA2X60 PA2X125 PA2X150 Power Output 25Wx2 60Wx2 125Wx2 150Wx2 45Wx2 90Wx2 180Wx2 225Wx2 90W 180W 360W 450W Total Harmonic <1%(Rated power: <1%(Rated power: <1%(Rated power: <1%(Rated power: Distortion (THD): 25W @ 8Ω) 60W @ 8Ω) 125W @ 8Ω) 150W @ 8Ω) Signal to Noise: >90 dB A WTD >90 dB A WTD >90 dB A WTD >90 dB A WTD Frequency Response: 20Hz~20KHz +0/- 20Hz~20KHz +0/- 20Hz~20KHz +0/- 20Hz~20KHz +0/- 2dB@ 8Ω 2dB@ 8Ω 2dB@ 8Ω 2dB@ 8Ω
TECHNICAL SUPPORT In case of problems, please contact Vanco Technical Support by dialing 1-800-626-6445. You can also email technical support issues to techsupport@ vanco1.com. When calling, please have the Model Number, Serial Number (affixed to the bottom of the unit) and Invoice available for reference during the call. Please read this Instruction Manual prior to calling or installing this unit, since it will familiarize you with the capabilities of this product and its proper installation.
Vanco ® International 506 Kingsland Drive Batavia, Illinois 60510 call: 800.626.6445 | fax: 630.879.9189 visit: www.vanco1.com Introducing a new brand from Learn more at pulseaudio1.
