User manual
6
SPEAKON™ SOCKETS AND SPEAKER TERMINAL POSTS - These
speakon™ connectors or Terminal posts are the output of the built in power
amplifier, (see spec table for model and Wrms).
IMPORTANT: Do not connect both speaker types at the same time doing so
can damage the built in amplifier. Make sure that the impedance of the speak-
ers are never less than 4Ω (ie 1x4Ω or 2x8Ω in parallel), otherwise the power
amplifier may become damaged. Make certain to always use only power
cables for speakers (1.5mm²) and not signal cable. You can also hard-wire
your speakers directly to the amplier using the terminal posts. Unscrew the
terminals until you can see the connections at the side of the post, make sure
you match the polarity of the speakers with the polarity on the ampliers, RED
+, BLACK ground. Insert the bare wire or the speaker and tighten the terminal
post until it grips the cable tightly. Make sure no bare wire is visible after you
have tightened the terminal.
Speakon; 1+ = speaker position, 1- = speaker negative
VENTILATION - In order to keep the mixers power amplier working correctly
it is essential that all the air vents are kept clear at all times and not near any
other product that is dissipating heat. The fan is used to not only cool down
the amplier but also do dissipate heat from the ventilation vents around the
amplier.