User manual

STEREO AUX RETURNS DIALS

The STEREO AUX RETURN 1 control determines the

level of signal in the main mix. If STEREO AUX RE-

TURNS 1 is used as effects return, this will determine

the level effect when mixed with any “dry” channel.

Note: when used this way, the effect device should be

set at 100% effect. The right hand dial is there to add an

effect to a monitor mix.

FX DIAL AND MAIN MIX / ALT 3-4 SWITCH

Works similar to the STEREO AUX RETURN. This

dial controls the level of signal from the AUX FX JACK

SOCKET back into the main mix.

The MAIN MIX/ALT 3-4 switch is used to send the sig-

nal from the FX DIAL to either the MAIN MIX FADER or

to ALT 3-4 fader.

MODE SWITCH - This switch switches between SOLO

(Solo In Place) and PFL (Pre Fader Listen). The LED

above this switch will illuminate to tell you what state

the switch is in. When in PFL mode the signals will be

shown on the LED display.

PFL (Pre Fader Listen)

The PFL function should be used for level setting

(GAIN). The signal is sourced pre-fader and assigned to

the mono PFL bus.

SOLO

This is used for listening to an individual signal or a

group of signals. When SOLO is activated all other

channels that are not SOLO selected are muted in the

control room / headphones. The SOLO bus carries the

output signals to the channel pan controls. Usually the

SOLO signals are monitored via the control room out-

puts and headphones jack and displayed on the level

meters.

LED DISPLAY

The top two LEDS are power on the left and phantom

power (+48V) on the right. The green, yellow and red

led’s are indicators for the signal level. If all the LEDS

illuminate then the signals are too high. Use the MAIN