User manual

PHONES 6.35mm (¼") SOCKET

Connect headphones to the mixer via this socket so

you can listen to individual channels, change settings

and listen to them separate from the audio signal being

played.

AUX SENDS DIAL AND SOLO SWITCH - Controls the

gain of all the AUX busses and sends the signal to the

AUX OUTPUT.

FX DIAL AND SOLO SWITCH - Controls the gain of all

the FX busses and sends the signal to the FX OUTPUT.

SOLO SWITCH - You can use the SOLO switch to

separately monitor the aux via the control room/phones

outputs and check these with the level meters.

BUTTON SELECTOR ,HEADPHONES GAIN CON-

TROL AND TAPE TO MAIN - The buttons are as

follows CD/TAPE, ALT 3-4 and MAIN MIX. You can

press any one of these channels to get a signal to come

through to the headphones. Pressing 2 will allow both

the signals to come through at the same time.

CTRL R. & PHONES - Use this dial to set control room

output level and headphone volume respectively

NOTE : When you are listening to your headphones

for the rst time make sure that the gain control dial is

turned fully anti-clockwise so if the audio signal is too

high it does not damage your hearing.

TAPE TO MAIN - When the TAPE TO MAIN switch is

pressed, the 2 track input is routed to the main mix and

thus serves as an additional input for tape machines.

You can also connect MIDI instruments or any other sig-

nal sources here that don’t require any further process-

ing. When you have pressed the TAPE TO MAIN this

switch also disables the main mix to tape output link