User manual

STEREO AUX RETURN SOCKET

BALANCED/UNBALANCED 6.35mm (¼") SOCKETS

AND LEVEL BUTTON

A stereo signal input via both left and right 6.35mm

(¼") sockets. Same as the other channels on the

mixer accept this channel can work in stereo. If you

wish to run in mono connect the left jack plug only.

The Level button is used to switch between two set-

tings to match the audio levels. The professional level

is considered to be +4 dBu. The homeowner level is

−10 dBV. Pressing the button will give you one or the

other state.

BALANCED DIAL on CH 5/6 & 7/8

This is used to control the left and right stereo signals

in the channel. Turning the dial to 7 o’clock means that

the majority of the Left signal will pass through to the

fader. Turning the dial to the 5 o’clock means that only

the majority of the Right signal will go through to the

fader.

INPUT TAPE 6.35mm (¼") SOCKET - This takes any

analogue signal and sends it to the main mix fader.

This could be anything from tape to MP3 players.

OUTPUT CD/TAPE 6.35mm (¼") SOCKET - This

takes the output signal from the main mixer and sends

it to any recordable device, e.g. Tape, CD or Laptops.

Note: With an adapter it may be possible to put your

laptop into the input and into the output at the same

time. So you can send a signal into the mixer and re-

cord the signal coming out from the main mix fader.

FX FOOT SWITCH 6.35mm (¼") SOCKET

Allows you to connect a foot switch to the mixer via a

6.35mm (¼") plug, this mutes the sound by pressing

down on the foot switch.