User`s manual

7
2.1. Quick installation
• Correct position - 2N
®
GSM ISDN GATEWAY Lite is designed for a vertical surface
Installation. Fix the bracket that is a part of the delivery to the wall and hang the gateway
onto it. Recommended working position and other more detailed recommendations are
described in chapter 3.1.
• Connecting cables - Use ISDN cables to connect the gateway to your ISDN PBX (or other
ISDN terminals). Connect the cables from your ISDN connection to the gateway. More
detailed information on correct connections are found in chapter 3.7.
• Antenna connection – Use the SMA antenna connector to connect either the entire
antenna or the cable from an external antenna you have installed in a place with a good
GSM signal (see 3.2).
• PC connection – To be able to adjust configuration of your gateway by means of the ISDN
GSM program, you must connect your gateway to a PC. The connection is performed by
means of a “not crossed” (1:1) extension cable – the same as for connecting PC to any
external modem (see 3.6).
• Power supply – The packing contains a mains supply adapter. Connect the connector of
the adapter to the gateway and plug it in the mains. The gateway is switched on immediately
(see 3.5 page 12).
• Inserting SIM cards – To be able to insert a SIM card you should use a suitable object to
press the micro-button of the microform reader to push the drawer out. Take the drawer out,
insert the SIM card into is and slide it back into the reader (see 3.3 and 3.4).
• Installing the configuration program – Run the installing file from the installation CD on a
connected PC and install the ISDN GSM configuration program (see
6.1).
• Configuration program – Run the installed ISDN GSM program, set the communication of
the serial channel where the gateway is connected. Start communication of your PC with the
gateway. More detailed information see
6.3.
• Configuring 2N
®
GSM ISDN GATEWAY Lite – Using the configuration program you can
now start adjusting parameters that determine the behaviour of your gateway. The adjusted
parameters include e.g. ISDN parameters, basic GSM parameters and tariffs, routing,
restrictions and system parameters. Set the parameters that correspond to the required
function of your gateway and send the configuration data to the gateway by means of the
serial channel. You can find some more detailed information on the configuration program in
chapter 6.
*To select basic settings for the ISDN GSM GATEWAY Lite, you can use a guide (installed together with
the ISDN GSM program).