User`s manual

CLIP routing
Fig.37: Routing – CLIP routing
This chart determines behaviour of the intelligent routing of incoming calls. In individual
lines the sequence goes like this:
- CLIP – calling line identification presentation
- Extension – DDI number (to which the call should be connected)
- Port – port to which the destined ISDN terminal is connected
- Validity – total time (days – max. 250) of record validity if 0 means permanently valid
- Mode – defines whether the “Remaining days” item should be restored to the “Validity”
value if an incoming call with this CLIP comes (1 – restored, 0 – not restored)
- Remaining days – number of days until the item is deleted from the chart (days are
always deducted at midnight).
- Callback – 0=Incomming call from GSM with defined CLIP has no activated Callback
function. 1=Incomming call from GSM with defined CLIP has activated Callback function,
- DISA to GSM – 0=Request for outgoing call with defined CLIP is rejected. 1=Request is
accepted and gateway will pict-up the call and give dial tone or tone for enter password.
- Callback number – optional enhancement of the callback function by the possibility of
calling back a different number
- DISA for Callback - After performing the callback function the caller will not be switched
to a defined branch. Instead, the caller will receive from the GSM gateway a voice DISA
notification to perform another DTMF dialing
- Incoming DISA from GSM – If the GSM gateway is set up to route incoming calls to a
defined branch, it will receive the defined CLIP DISA DTMF dialing instead of direct
connection using this parameter.
- ME – allowing/banning ME for the selected CLIP
- Follow me – allowing/banning the function of call routing from ISDN to GSM (included in
the ME function)
- SMS at no answer – allowing/banning the function for a selected CLIP
*Note: Items can be added to the CLIP Routing chart using a telephone (see 5.6).
To make CLIP work properly, satisfy the following conditions:
Complete the correct national prefix in the National Destination chart (see 6.5.4.3 page
48).
The international installation site must be identical with the international prefix included in
the CLIP Routing chart (see
6.5.4.2 page 47).
Enter the number in the long-distance call format (0603xxxxxx, 02xxxxxxxx, e.g.).
46