User`s manual

Dialling mode

This parameter determines the mode of transferring numbers in the TE<>NT

communication. There are two ways of number transfer in the ISDN - either in a data

packet called “setup” or in packets called “info”.

- Overlap, this parameter determines that the “setup” packet does not contain any

number and all digits are sent in “info” packets. This parameter is used for

communication with some PBXs. Never use it for ISDN telephones.

- Enblock, this parameter determines that the whole number is sent in the “setup” packet.

This parameter must be set for those ports to which an ISDN telephone or similar

terminal is connected.

- Onsetup, this parameter combines both the above-mentioned parameters and is set for

ISDNs and most PBXs. Never use it for ISDN telephones.

DISA to GSM

Global activation/deactivation of the function on the selected port. The DISA to GSM is

DTMF dial-in to GSM networks. In cases of the GSM gateway is installed to a extension

of your PBX or on a ISDN bus with more than one TE terminals. In second case is

necessary to set for selected port right MSN number (the GSM gateway will accept only

call requests with this number). In case that MSN number isn't present, the GSM gateway

will accept all requests. The MSN number you set in section "Routing>Trunk lines" (see

6.5.4.6 page 50). For right instalation is necessary to set up correctly all additional

parameters in sections "Routing>General parameters" (see 6.5.4.1 page 44) and

"Routing>CLIP routing" (see 6.5.4.6 page 50.).

Send to ISDN progress -

In case that the parameter is switched on, th GSM gateway will

inform your ISDN equipment that calling phone is in non-ISDN network (call is routed to

GSM network) and require voice connection via B-channel before the connection with

caled party (in this case the calling party can hear all tones and voice messages from

GSM network). When the parameter is switched off, the ring tone is generated by your

ISDN equipment

Send CONNECT_ACK in TE mode -

The gateway in TE mode sends optional ISDN message

CONNECT ACK. This message can be required by some of Ericsson PBX

Don’t send TE progress in SETUP_ACK - Removal of the TE progress from corfirmation

message in ISDN communication. It is neccessary to use this parameter with some of

Alcatel PBXes (e.g. Alcatel 4400)

Mode of dial tone - Sets type of dial tone with activated DISA function on TE port.

Error ISDN cause - Number of ISDN cause, which the GSM gateway will sends back in

REJECT message. This message is sent in case, that the GSM gateway receives

request for make outg. call and there is no free way(route) for this call - call will be

rejected. In case that you're using intellingent PBX/Router you can reroute (and

establish) this call via another device. If this parameter is switched off, the gateway sends

CAUSE number=1.

Convert keypad facility dial to called party number–

Some ISDN terminal are sending letters

“#” and “*” as Keypad facility dial mode. With activate this parameter gateway will convert

this dial to Called party number.