User manual

Commands for initialising: No. Parameter

Basic parameters 991

Interface for external line of PBX 992

Interface for local line of PBX 993

Universal inputs and outputs 994

Call sorting table 995

Intelligent Incoming Call Routing Table 996

Parameters for "Dial-thru" model 997

Operation monitoring and signalling 998

Complete initialisation 999

Valid service password must be

entered as a parameter as

verification to avoid inadvertent

initialisation e.g. when this function

is entered by mistake. Default

value of service password is

12345.

Notes:

901 – Service Password: If you change the password, remember it well. If you forget it, contact

the GSM Gateway manufacturer. The service password is not changed by initialisation!

Warning:

GSM gateways, shipped to some customers, may contain pre-programmed values for use in

target country, to make installation as easy as possible. Commands 995, 996 and 999 erases

these settings, i.e. local GSM operator prefixes in call sorting table and international prefix -

parameter 6002.