User manual

6.5.6. How to make GSM Gateway ready for Remote Supervision
1
2
3
4
5
7
8
9
1
1
6
10
12
1. Connect the GSM gateway to your PC and run the GSM program.
2. Switch into the on-line mode.
3. If the connection fails, select the correct serial port number in the ‘Setting’ menu.
4. Read the GSM gateway setup.
5. Open the ‘Service Parameters’ item.
6. Open the remote supervision parameter folder.
7. Make sure that remote supervision is enabled. If not, enable it.
8. Enter the number of the modem or GSM gateway, which is used for remote supervision.
9. If you select the call-back item, and the GSM gateway, which is used for remote supervision,
has a separate data number, enter the data number in the right-hand column.
10. You can enter up to 4 numbers to be used for remote supervision.
11. Remember to save the setup back into the GSM gateway.
12. Switch into the off-line status.
Important recommendation:
You are recommended to make this setup before installing the GSM gateway at the client’s.
With older types of GSM gateways already installed, you are advised to make this setup
immediately after software upgrade to a version supporting remote supervision – 2.36 and up.
40