User manual

6.3. Handset-Based Programming
6.3.1. Requirements and Recommendations
• You need another extension of the same PBX and a tone-dialling telephone set for
programming.
• Use the telephone-based programming only if you do not want to set up many
parameters. Remember that you do not have any feedback with a telephone!
• Complete the prepared form first – think before programming!
6.3.2. Entering Programming Mode
• Pick up the handset. If you have a phone connected directly with GSM gateway, go to
next step. Otherwise, dial the number to access GSM Gateway. *)
• Wait until you can hear the dial tone
. You cannot program during the current
call, or if the GSM Gateway requires a PIN or PUK code.
• To get into the programming mode enter the service password and the character.
The GSM Gateway transmits a confirmation
.
• If you make a mistake while entering the password, cancel the entering by hanging-
up (the
character cannot be used) and start again.
• The service password is ‘12345‘ by default. We recommend changing the password
to protect your equipment against unauthorized persons. If you forget the password,
your data will not get lost, but you will have to contact the manufacturer.
• If you enter an incorrect password that is not bared by sorting table, the GSM
Gateway dials the number and may get through somewhere. This, however, is
almost improbable. In case of GSM gateway model for external line and pulse dialling
selected, there is no such a risk; GSM gateway sends busy tone if any other number
than correct password is entered.
Example: correct password
, you enter incorrectly
, the number is dialled and you will get through to the
emergency line 112.
*) Note: You must access GSM gateway by its PBX line interface. Programming by GSM
connection (incoming call) or by PSTN call is not possible.
6.3.3. Telephone-Based Programming
Once you have entered the programming mode, you can change all parameters or
more parameters in any sequence, except for SMS message texts or I2CR table
parameters. It is easy – just enter the parameter number and then the parameter value. Use
the
as separator ("Enter").
Each parameter number has three to four digits (refer to the Parameter Tables). After
the number and
are entered, the GSM Gateway sends a confirmation
signal if such
parameter exists and is available in the particular model and software version. If it is not
available, the GSM Gateway transmits a rejection signal
. After the value and
another
are entered, the GSM Gateway sends a storing signal if the value lies in
the allowed interval. If not, the GSM Gateway transmits a rejection signal
. The
programmed values are stored immediately during the storing signal
transmission.
34