User manual

i-Flash Technology Limited
Rm 1110, 11F, Fabrico Industrial
Buildings, 78 Kwai Cheung Road,
Kwai Chung, NT. Hong Kong
Web:
Tel:
Fax:
Email:
www.iflashtec.com
[phone]
[phone]
[e-mail]
PULSE FXI6 Series Installation Guide
11 | P a g e
Connect to the Camera using Static IP
If the camera does not get response from DHCP server after 3 minutes, it can be accessed by the default
IP 192.168.1.168.
1. Connect your PC to the same network as the FXI6.
2. Configure the IP address of your PC to: 192.168.1.XXX (1<XXX<255) and configure the subnet
mask to 255.255.255.0.
3. Make sure that the device is turned on and connected to the network.
4. Start Internet Explorer on your computer.
5. Enter 192.168.1.168 in the address bar of the browser.
6. Enter the administrator user name and password to access the Web Configuration Interface
7. The default user name and password are both set to admin.
8. IE will indicate that the add-on is required, install this add-on by following the instructions in IE.
9. You will see the home page.