User`s guide

80 CHAPTER 6: TECHNICAL REFERENCE
S Registers
Table6-3
Register Default Function
S0 0 Sets number of rings on
which to answer in Auto
Answer mode. When set to
0, Auto Answer is disabled.
S1 0 Counts and stores number of
rings from an incoming call.
(S0 must be greater than 0.)
S2 43 Stores ASCII decimal code for
the escape code character.
Default character is +. A
value of 128 - 255 disables
escape code.
S3 13 Stores ASCII code for the
Carriage Return character.
Valid range is 0 - 127.
S4 10 Stores ASCII decimal code for
the Line Feed character. Valid
range is 0 - 127.
S5 8 Stores ASCII decimal code for
the Backspace character. A
value of 128-255 disables
Backspace key's delete
function.
S6 2 Sets number of seconds
modem waits before dialing.
If Xn is set to X2 or X4, this is
time-out length if no dial
tone.
S7 60 Sets number of seconds
modem waits for a carrier.
May be increased as needed,
for example to allow modem
time to establish an
international connection.
S8 2 Sets duration, in seconds, for
pause (,) option in the Dial
command. Valid range is
0-32.