User`s guide

Internal PCI Modems 45
the properties of modems from this window. The U.S. Robotics modem
you have installed should be present in the list of installed modems. If
none of the modem descriptions in the list matches your U.S. Robotics
modem or no modems are listed, your modem is not properly installed.
Try reinstalling your modem using the instructions on the Installation
Guide.
Possible solution:
Windows 2000If you are using Dial-Up Networking, it may not be
configured correctly. Check your configuration and make sure you have
the correct port selected. Click Start, point to Settings and click
Network and Dial-up Connections. Make sure that the description in
the “Connect Using” box (under the General tab) matches the
description of the modem you are using. If it doesn't match, select the
proper modem description.
Windows 95/98/NTIf you are using Dial-Up Networking, it may not be
installed or configured correctly. Check your configuration and make sure
you have the correct modem selected. Double-click My Computer,
double-click Dial-Up Networking, right-click the connection you are
trying to use, and click Properties. Make sure that the description in the
modem box matches the description of the modem you are using. If it
doesn't match, select the proper modem description.
My modem won't
dial out or doesn't
answer incoming
calls.
FOR BOTH DIALING AND ANSWERING PROBLEMS:
Possible solution:
You may have a bad phone cord connection to your modem, or your
phone cord may be plugged into the wrong jack. The phone cord should
be plugged into the jack labelled on the modem and into the wall
phone jack. Use the phone cord included in your modem's box if
possible.
Possible solution:
You may have devices between the modem and the phone jack. There
should be no line splitters, fax machines, or other devices between the
modem and the wall jack.