Owners Manual

4005-SSP

4005-SSB

4005-ORB

IMPORTANT

INSTALLATION QUESTIONS

Check local code for proper placement

of ErgoSafetyBar to meet requirement

such as ADA or ANSI 117.1 Consumer

Safety Requirements.

ERGOSAFETYBAR CAN BE MOUNTED

THROUGH SHOWER WALL AND

SCREWED DIRECTLY TO WOOD OR

METAL STUD WHEN APPLICABLE.

Before returning your ErgoSafetyBar

to the store or have any question about

installation or missing parts please

visit the CUSTOMER CARE area on our

website www.PulseShowerSpas.com.

INSTALLATION INSTRUCTIONS

TOOLS REQUIRED FOR INSTALLATION

Electric Drill

1/8” wood or metal drill bit

5/16” masonry drill bit

Tape measure

Screwdriver

Level

ALL PICTURES SHOWN ARE FOR ILLUSTRATION PURPOSE ONLY. ACTUAL PRODUCT MAY VARY DUE TO PRODUCT ENHANCEMENT.

WARRANTY

Please visit

www.PulseShowerSpas.com for

our Manufacture’s Lifetime Limited

Warranty information.

SafetyBar

Ergo

SlideBar

Ergo

PAGE 1
INSTALLATION INSTRUCTIONS Ergo SafetyBar Ergo SlideBar 4005-SSP 4005-SSB 4005-ORB TOOLS REQUIRED FOR INSTALLATION Electric Drill 1/8” wood or metal drill bit 5/16” masonry drill bit Tape measure Screwdriver Level IMPORTANT INSTALLATION QUESTIONS Check local code for proper placement of ErgoSafetyBar to meet requirement such as ADA or ANSI 117.1 Consumer Safety Requirements.
PAGE 2
PARTS INCLUDED • Stainless steel rail • Mounting screws • Washers WARNING: BOTH ends of grab bar must be installed into WOOD wall studs INSTALLATION STEP 1 Position mounting flanges and mark hole locations. For wood or solid backing applications drill 1/8” pilot holes through shower wall into wood or metal stud. NOTE: If wall is tiled, drill a 1/8” pilot hole through tile then change to the a 5/16” diameter masonry tile drill bit.