Installation Guide

4003-SSP

4003-SSB

4003-ORB

IMPORTANT

INSTALLATION QUESTIONS

Check local code for proper placement

of ErgoCornerBar to meet requirement

such as ADA or ANSI 117.1 Consumer

Safety Requirements.

ERGOCORNERBAR CAN BE MOUNTED

THROUGH SHOWER WALL AND

SCREWED DIRECTLY INTO WOOD

FRAMING.

Before returning your ErgoCornerBar

to the store or have any question about

installation or missing parts please

visit the CUSTOMER CARE area on our

website www.PulseShowerSpas.com

or send us an email to

support@pulseshowerspas.com.

INSTALLATION INSTRUCTIONS

TOOLS REQUIRED FOR INSTALLATION

Electric Drill

1/8 inch wood drill bit

1/4 inch masonry drill bit

Tape measure

Screwdriver

Level

ALL PICTURES SHOWN ARE FOR ILLUSTRATION PURPOSE ONLY. ACTUAL PRODUCT MAY VARY DUE TO PRODUCT ENHANCEMENT.

WARRANTY

Please visit

www.PulseShowerSpas.com for our

Manufacture’s Limited Warranty

information.

CornerBar

Ergo

PAGE 1
INSTALLATION INSTRUCTIONS Ergo CornerBar 4003-SSP 4003-SSB 4003-ORB TOOLS REQUIRED FOR INSTALLATION Electric Drill 1/8 inch wood drill bit 1/4 inch masonry drill bit Tape measure Screwdriver Level IMPORTANT INSTALLATION QUESTIONS Check local code for proper placement of ErgoCornerBar to meet requirement such as ADA or ANSI 117.1 Consumer Safety Requirements.
PAGE 2
PARTS INCLUDED • ErgoCornerBar with storage shelf • Mounting hardware INSTALLATION STEP 1 Place product in desired mounting location. Make sure product is flush against both walls. Use level to check horizontal alignment. STEP 2 Use pencil to mark all 4 holes. STEP 3 Determine if plumbing, electrical or any other obstructions are contained behind wall surface prior to drilling. If drilling directly into wood framing use 1/8-inch drill bit ONLY.