Installation Guide

4001R-SSP

4001R-SSB

4001R-ORB

4001L-SSP

4001L-SSB

4001L-ORB

SlideBar

Ergo

IMPORTANT

INSTALLATION QUESTIONS

Check local code for proper placement

of ErgoSlideBar to meet requirement

such as ADA or ANSI 117.1 Consumer

Safety Requirements.

ERGOSLIDEBAR CAN BE MOUNTED

THROUGH SHOWER WALL AND

SCREWED DIRECTLY TO WOOD OR

METAL STUD WHEN APPLICABLE.

Before returning your ErgoSlideBar to

the store or have any question about

installation or missing parts please

visit the CUSTOMER CARE area on our

website www.PulseShowerSpas.com.

INSTALLATION INSTRUCTIONS

TOOLS REQUIRED FOR INSTALLATION

Electric Drill

1/8” wood or metal drill bit

5/16” masonry drill bit

Tape measure

Screwdriver

Level

ALL PICTURES SHOWN ARE FOR ILLUSTRATION PURPOSE ONLY. ACTUAL PRODUCT MAY VARY DUE TO PRODUCT ENHANCEMENT.

WARRANTY

Please visit

www.PulseShowerSpas.com for our

Manufacture’s Limited Warranty

information.

PAGE 1
INSTALLATION INSTRUCTIONS Ergo SlideBar 4001R-SSP 4001R-SSB 4001R-ORB 4001L-SSP 4001L-SSB 4001L-ORB TOOLS REQUIRED FOR INSTALLATION Electric Drill 1/8” wood or metal drill bit 5/16” masonry drill bit Tape measure Screwdriver Level IMPORTANT INSTALLATION QUESTIONS Check local code for proper placement of ErgoSlideBar to meet requirement such as ADA or ANSI 117.1 Consumer Safety Requirements.
PAGE 2
PARTS INCLUDED • Stainless steel rail • 3 Function handheld with flow control • 72” Shower hose • Installation manual • Shower arm mount with hand held holder • Hand held slider INSTALLATION STEP 1 Position mounting flanges and mark hole locations. For wood or solid backing applications drill 1/8” pilot holes through shower wall into wood or metal stud. NOTE: If wall is tiled, drill a 1/8” pilot hole through tile then change to the a 5/16” diameter masonry tile drill bit.