Specifications

4.4 Dead-Band Submodule Registers
Dead-Band Submodule Registers www.ti.com
Table 4-13. Action-qualifier Continuous Software Force Register (AQCSFRC) Field Descriptions
(continued)
Bits Name Value Description
3-2 CSFB Continuous Software Force on Output B
In immediate mode, a continuous force takes effect on the next TBCLK edge.
In shadow mode, a continuous force takes effect on the next TBCLK edge after a shadow load into
the active register. To configure shadow mode, use AQSFRC[RLDCSF].
00 Forcing disabled, i.e., has no effect
01 Forces a continuous low on output B
10 Forces a continuous high on output B
11 Software forcing is disabled and has no effect
1-0 CSFA Continuous Software Force on Output A
In immediate mode, a continuous force takes effect on the next TBCLK edge.
In shadow mode, a continuous force takes effect on the next TBCLK edge after a shadow load into
the active register.
00 Forcing disabled, i.e., has no effect
01 Forces a continuous low on output A
10 Forces a continuous high on output A
11 Software forcing is disabled and has no effect
Figure 4-14 through Figure 4-16 and Table 4-14 through Table 4-16 provide the register definitions.
Figure 4-14. Dead-Band Generator Control Register (DBCTL)
15 8
Reserved
R-0
7 6 5 4 3 2 1 0
Reserved IN_MODE POLSEL OUT_MODE
R-0 R/W-0 R/W-0 R/W-0
LEGEND: R/W = Read/Write; R = Read only; -n = value after reset
106 Registers SPRU791F – November 2004 – Revised July 2009
Submit Documentation Feedback