MSDS
                                       Material Safety Data Sheet 
Version: 2.1  update: 2012/01                                                                           Page 2 of 4 
Section 4 first-aid measures 
The valve-regulated lead-acid batteries are not hazardous with eye and skincontact under normal 
circumstance. In case of internal hazardous substanceleaking, following measures should be taken if body 
parts contact with these substance: 
AFTER SKIN CONTACT: 
In case of contact, immediately wash skin with soap and copious amounts of water. 
AFTER EYE CONTACT: 
In case of contact, flush eyes with clean water for 15 minutes while lifting eyelids.Get prompt medical attention. 
AFTER INHALATION: 
If inhaled, remove to fresh air. If not breathing give artificial respiration. If breathing is difficult, give oxygen. 
AFTER INGESTION: 
If swallowed, wash out mouth with water provided person is conscious. Call a physician. 
Section 5 fire-fighting measures 
Characteristics of Hazard  : Toxic fumes; gases or vapors may evolve on burning. 
Hazardous Combustion Products:  CO,  CO2, acid, hydrogen and oxygen gas 
Fire-extinguishing Methods and Extinguishing Media: Carbon dioxide, dry chemical powder, or appropriate foam 
Attention in Fire-extinguishing: The Firemen should put on antigas masks and full fire-fighting suits. 
Section 6 accidental release measures 
When leakage of batteries happens, liquid could be absorbed with sands, earth, or other inert substance, and the 
contaminated area should be ventilated meantime. Damaged batteries that are not hot or burning should be placed in a 
sealed plastic bag or container. 
Section 7 handling and storage 
Handling: don’t handling the batteries in manner that allows terminals to short circuit 
Storage: Store and used far away from heat, sparks, open flame, or other heat ignition sources, and under room 
temperature(<30) in ventilating and dehumidifying℃  environments 
Section 8 exposure controls/personal protection 
Maximum Allowable Concentration: No Standard available 
Engineering Controls: no engineering controls are required for handling batteries that have not been damaged. 
Personal protective equipments for damaged batteries should include chemical resistant gloves and safety glasses. 








