Installation Guide

5
Assembly
After unpacking your ShowerSpa, some assembly is required prior to installation.
Shelf Assembly
1. Place ShowerSpa (1) onto top of shelf (2) and insert shelf mounting screws (8) through holes.
2. Place metal washers (9) on screws (8) and secure shelf mounting nuts (10) to underside of shelf. Use an
adjustable wrench to tighten.
Diverter Hose Assembly
1. Attach jet hose (17) to jet outlet (not shown) located on diverter (3). Make sure jet hose (17) is attached to
outlet located on right side when facing ShowerSpa (1). Tighten with adjustable wrench.
2. Attach rain shower hose (16) to rain shower outlet (18) which is the highest oulet located left of jet outlet on
diverter (3) when facing unit. Tighten with adjustable wrench.
3. Attach supply hose (12) to supply inlet (not shown) located on diverter (3). Make sure supply hose (12) is
attached to outlet which is located closest to back of ShowerSpa (1). Tighten with adjustable wrench.
Hand Shower Assembly
1. Insert washer (4) into hexagon-shaped end of hand shower hose (5) and attach to threaded outlet on bottom
of ShowerSpa. Do not over-tighten.
2. Insert washer (4) into tapered end of hand shower hose (5) and attach to hand shower (7). Insert hand shower
into holder (6).