Owner's Manual

Assembly

After Unpacking Your ShowerSpa, Some Assembly Is Required Prior To Installation

Shower Arm Assembly

1. Thread shower arm (3) into shower arm insert (4) completely. NOTE: Shower arm should pivot side-to-side.

2. Insert rubber washer (12) in showerhead (2) and tighten showerhead onto show arm (3).

Handshower Holder Assembly

1. Mark preferred mounting location of handshower holder (7). Drill ¼" hole into wall surface (CAUTION: LIVE PLUMBING) for handshower

mount anchor (11).

2. Secure handshower holder mount (5) to wall surface by tightening handshower mount screw (10) into anchor (11).

3. Slide handshower holder (7) onto mount (11) and secure with set screw (8).

After ShowerSpa Is Mounted To The Wall

Connect The Handshower

1. Insert washer (12) into hexagon shaped end of handshower hose (9) and attach to threaded outlet on bottom of ShowerSpa (1). Do not

over-tighten.

2. Insert washer (12) into tapered end of handshower hose (9) and attach to handshower (6). Insert handshower into holder (7).

Attach Showerhead

1. Insert rubber washer (12) into showerhead (2) and hand tighten onto the shower arm (3).