Barcelona ShowerSpa Model #1040 PW-91040-5725BRZ Owner's Manual
Barcelona ShowerSpa Model #1040 / PW-91040-5725BRZ Please Read The Following Instructions COMPLETELY Before Beginning! Our goal is to ensure your installation goes smoothly and safely. Please read these instructions carefully and follow recommendations for plumbing and mounting. After reading instructions, if you determine you do not have the necessary skills and/or tools, we recommend that a licensed plumbing contractor complete the installation.
Dimensions 3.94 in. 100 mm 7.87 in. 200 mm 5.75 in. 146 mm 16.54 in. - 420 mm 7.87 in. 200 mm 58.46 in. - 1485 mm 16.93 in. - 430 mm 51.97 in. - 1320 mm 18.31 in. - 465 mm 8.27 in. 210 mm 3.94 in. 90 mm 7.09 in. 180 mm 11.02 in. 280 mm 2.58 in. 65.
Parts Legend 1. ShowerSpa 6. Handshower 11. Handshower Mount Anchor 2. Showerhead 7. Handshower Holder 12. Rubber Washer ...............3 3. Shower Arm 8. Set Screw 13. Wall Mount Bracket........2 4. Shower Arm Insert 9. Handshower Hose 14. Wall Mount Screw ..........4 5. Handshower Holder Mount 10. Handshower Mount Screw 15. Wall Mount Anchor.........
Assembly After Unpacking Your ShowerSpa, Some Assembly Is Required Prior To Installation Shower Arm Assembly 1. Thread shower arm (3) into shower arm insert (4) completely. NOTE: Shower arm should pivot side-to-side. 2. Insert rubber washer (12) in showerhead (2) and tighten showerhead onto show arm (3). Handshower Holder Assembly 1. Mark preferred mounting location of handshower holder (7). Drill ¼" hole into wall surface (CAUTION: LIVE PLUMBING) for handshower mount anchor (11). 2.
nstallation New Construction or Extensive Remodel – New Finished Wall Surface 1. Prior to sheetrock, stub-out ½" hot and cold supply lines beyond finished wall surface, 4" on center. For best results, attach 90° brass fittings (available at most hardware stores) to the stub-outs maintaining ¼" – ½" of space between the fitting and finished wall. The open end of the 90° brass fittings should point down so the supply lines attach parallel to the wall. 1 2.
Usage Pressure Balance Mixing Valve This ShowerSpa is equipped with a cUPC® pressure balance mixing valve to adjust water flow and temperature. The valve automatically adjusts to changes in water pressure (i.e. someone flushes a toilet), keeping your temperature constant and preventing accidental scalding. To turn on the ShowerSpa simply raise the handle until the desired flow rate is achieved. Rotate to the right to decrease temperature and rotate to the left to increase temperature.
Manufacturer’s Lifetime Limited Warranty 1. Defects Covered; Warranty Period. Pulse Shower Spas, Inc. (“Pulse”) warrants to the original consumer purchaser who purchases this shower spa (the “Product”) for use in his or her own home, that the Product will be free from defects in material and manufacturing workmanship for as long as the original consumer purchaser owns that same home.
