Installation Guide

5
Assembly
Some Assembly is Required Prior to Installation.
Slide Bar Assembly Refer to exploded line drawing for reference.
1. Hold slide bar (4) with grooves facing away from you. Press button on hand
shower holder (8) and place onto slide bar (4) with holder facing you and
button on top.
2. With slide bar (4) facing you, align grooves on bracket (5) with grooves on
back of slide bar (4). Screw holes on bracket (5) should extend to left side of
bar. Insert bracket (5) until flush with opening. Push cap (6) into slide bar (4)
opening. Repeat for other end.
3. Align assembled slide bar with pre-drilled holes on right side of ShowerSpa.
Secure with machine screws (10) and lock washers (11).
After ShowerSpa is Mounted to Wall
Attach Hand Shower and Hose
1. Insert rubber washer (12) into hexagon shaped end of hand shower hose (9)
and attach to threaded outlet on bottom of ShowerSpa.
DO NOT OVER-TIGHTEN.
2. Insert rubber washer (12) into tapered end of hand shower hose (9) and attach
to hand shower (7). DO NOT OVER-TIGHTEN. Insert hand shower (7) into
holder on slide bar (4).
Attach Shower Head
3. Insert rubber washer (12) into showerhead (2) and hand tighten onto the shower
arm (3).