Owner's Manual

5
Assembly
After Unpacking Your ShowerSpa, Some Assembly Is Required Prior To Installation
Handshower Holder Assembly Figure A
1. Place the threaded end (on main axis) of the handshower holder (5) into the handshower outlet (7). Make certain the threads for the
handshower hose are pointing down. Refer to diagram for proper positioning.
2. Tighten handshower holder (5) to ShowerSpa (1) with nut (6).
3. Check the open end of the hose on back of ShowerSpa for a rubber washer (17). If no washer is present, place one into the hose. Tighten
hose to the handshower holder (5) making sure there are no kinks in the hose. DO NOT OVERTIGHTEN.
4. Check connection for leaks after supply lines are connected.
Showerhead Assembly Figure B & C
1. Align the four mounting holes of the showerhead with the holes in the top of the ShowerSpa panel.
2. Refer to the diagram for proper placement of bolts (13), washers (12), lock washers (11) and nuts (10). Secure the showerhead to the
panel with supplied allen wrench (9). Make certain the connection is tight and there is no "play" between the two items.
 3. RoutehosesfrominsideShowerSpa(1)throughtheholesinbackofshowerhead(2).Connecthosestotheshowerheadttingsmaking
sure there are no kinks in the hoses. DO NOT OVERTIGHTEN.
4. After the unit is installed, check these connections to ensure there are no leaks.
 5. Slidecover(8)intothetopoftheshowerhead(2)withthengerholetowardsthebackside.
*NOTE: Seat is not ADA Compliant.
After ShowerSpa Is Mounted To The Wall
Connect The Handshower
1. Insert a rubber washer (17) into the hex end of the shower hose (4), and attach to the handshower holder (5).
2. Insert a rubber washer (17) into the tapered end of the shower hose (4) and attach to the handshower (3). Place the tapered end of the
hose into the handshower holder (5).