Oahu ShowerSpa Model #1035 PW-91035-1825BSS Owner's Manual
Oahu ShowerSpa Model #1035 / PW-91035-1825BSS Please Read The Following Instructions COMPLETELY Before Beginning! Our goal is to ensure your installation goes smoothly and safely. Please read these instructions carefully and follow recommendations for plumbing and mounting. After reading instructions, if you determine you do not have the necessary skills and/or tools, we recommend that a licensed plumbing contractor complete the installation.
14.75 in. 374.65 mm 8.625 in. 219.075 mm 11.25 in. 285.75 mm 39.375 in. - 1000.125 mm 10.75 in. 10.75 in. 273.05 mm 273.05 mm 16.5 in. 419.1 mm 7 in. 177.8 mm 26.5 in. - 673.1 mm 13.75 in. 346.25 mm 31 in. - 787.4 mm 76 in. - 1930.4 mm Dimensions 23.5 in. - 596.9 mm 18 in. - 457.2 mm Finished Wall Line Measured To Bottom Of Bracket 10 in. 254 mm Measured To Bottom Of Bracket 3 in. - 76.
Parts Legend 1. ShowerSpa 8. Cover 15. Mounting Screw........... 12 2. Showerhead 9. Allen Wrench 16. Nylon Anchor................ 12 3. Handshower 10. Nut......................................4 4. Shower Hose 11. Lock Washer.....................4 17. Rubber Washer (3 extra)...........................6 5. Handshower Holder 12. Washer...............................8 18. Flow Restrictor................2 6. Large Nut 13. Bolt.....................................4 19.
Assembly After Unpacking Your ShowerSpa, Some Assembly Is Required Prior To Installation Handshower Holder Assembly Figure A 1. Place the threaded end (on main axis) of the handshower holder (5) into the handshower outlet (7). Make certain the threads for the handshower hose are pointing down. Refer to diagram for proper positioning. 2. Tighten handshower holder (5) to ShowerSpa (1) with nut (6). 3. Check the open end of the hose on back of ShowerSpa for a rubber washer (17).
Installation New Construction or Extensive Remodel – New Finished Wall Surface 1. Prior to sheetrock, stub-out ½" hot and cold supply lines beyond finished wall surface, 4" on center. For best results, attach 90° brass fittings (available at most hardware stores) to the stub-outs maintaining ¼" – ½" of space between the fitting and finished wall. The open end of the 90° brass fittings should point down so the supply lines attach parallel to the wall. 1 2.
Usage Thermostatic Mixing Valve This ShowerSpa comes equipped with a thermostatic mixing valve to safely control water temperature. Once you set the knob to the desired operating temperature, the thermostatic mixing valve will regulate the temperature, keeping it constant even when water pressure drops inside the plumbing lines (i.e. someone flushes a toilet, etc.). The button on the knob points to the current water temperature.
Manufacturer’s Lifetime Limited Warranty 1. Defects Covered; Warranty Period. Pulse Shower Spas, Inc. (“Pulse”) warrants to the original consumer purchaser who purchases this shower spa (the “Product”) for use in his or her own home, that the Product will be free from defects in material and manufacturing workmanship for as long as the original consumer purchaser owns that same home.
