Owner's Manual

7
Usage
Pressure Balance Mixing Valve
This ShowerSpa is eqiuipped with a cUPC® pressure balance mixing valve to adjust water ow and
temperature. The valve automatically adjusts to changes in water pressure (i.e. someone ushes a
toilet), keeping your temerature constant and preventing accidental scalding. To turn on the ShowerSpa
simply raise the handle until the desired ow rate is achieved. Rotate to the right to decrease
temperature and rotate to the left to increase temperature. Be sure that the handle is in the OFF
position when you are done using your ShowerSpa so that pressure does not build up inside the unit.
Brass Diverter
The brass diverter is used to change between ShowerSpa functions. Simply rotate the diverter knob
either direction to select the desired function—showerhead, handshower or body jets.
Body Jets
This ShowerSpa is eqiuipped with four 3-function brass Innity Jets™ with 3 spray patterns. The angle
of each jet can be adjusted by simply tilting the jet.
Handshower
The handshower has three individual functions and two combo functions. Rotate the head of the
handshower left or right to change between the power spray, pulsating massage or gentle cascade
functions. To adjust angle of handshower, loosen ring on the handshower holder, gently rotate toward
you or the wall, then tighten ring.
Care and Maintenance
Always blot dry any water from the surface of your ShowerSpa. To help protect your ShowerSpa
from hard water stains and mineral deposits, use an auto spray wax periodically and wipe down your
ShowerSpa after each use. Allowing water to evaporate on the surface can lead to a buildup of mineral
deposits. Cleaning with a damp, nonabrasive sponge and drying with a clean soft cloth should help keep
your ShowerSpa looking beautiful.
REMEMBER
NEVER use any abrasives or harsh cleaners!
Clean with mild soap and water ONLY!
To keep your ShowerSpa in pristine condition,
DRY AFTER EACH USE!