Navajo ShowerSpa Model #1018 PW-91018-5125HCO Owner's Manual
Navajo ShowerSpa Model #1018/PW-91018-5125HCO Please Read The Following Instructions COMPLETELY Before Beginning! Our goal is to ensure your installation goes smoothly and safely. Please read these instructions carefully and follow recommendations for plumbing and mounting. After reading instructions, if you determine you do not have the necessary skills and/or tools, we recommend that a licensed plumbing contractor complete the installation.
Mounting Bracket & Stub-out Location 8" 25" Estimated Mounting Height And Stub-out Location For Individuals 5'8"– 6'2" 90˚ Fittings Not Included 56" 4" Mark Bottom Of ShowerSpa Where It Contacts The Wall 31" 24" Floor 3
Parts Legend 4 1. ShowerSpa 9. Handshower Hose 2. Shower Arm 10. Handshower Holder 17. Rubber Washer............... (4) 18. Glass Shelf 3. Showerhead 11. Mounting Screw A 19. Shelf Mount..................... (2) 4. Large Rubber Washer... (2) 12. Nylon Anchor A 20. Shelf Set Screw............... (2) 5. Brass Nut.......................... (2) 13. Handshower Outlet 21. Set Screw 6. Shower Arm Outlet 14. Mount Bracket 22. Wall mount 7. Shower Arm Supply Line 15. Mounting Screw B..........
Assembly After Unpacking Your ShowerSpa, Some Assembly Is Required Prior To Installation Shower Arm Assembly Figure A 1. Before installing the shower arm (2) you need to align the mounts to the shower arm outlets (6). Loosen set screw (21) inside the top mount of the shower arm (2) with a 4mm allen wrench. Position so both mounts line up with the two shower arm outlets (6) on the front of the ShowerSpa. Gently tighten the set screw (21) inside the top mount—DO NOT OVERTIGHTEN. 2.
Installation New Construction or Extensive Remodel – New Finished Wall Surface 1. Prior to sheetrock, stub-out ½" hot and cold supply lines beyond finished wall surface, 4" on center. For best results, attach 90° brass fittings (available at most hardware stores) to the stub-outs maintaining ¼"– ½" of space between the fitting and finished wall. The open end of the 90° brass fittings should point down so the supply lines attach parallel to the wall.1 2.
Usage Pressure Balance Mixing Valve This ShowerSpa is eqiuipped with a cUPC® pressure balance mixing valve to adjust water flow and temperature. The valve automatically adjusts to changes in water pressure (i.e. someone flushes a toilet), keeping your temerature constant and preventing accidental scalding. To turn on the ShowerSpa simply raise the handle until the desired flow rate is achieved. Rotate to the right to decrease temperature and rotate to the left to increase temperature.
MANUFACTURER'S LIFETIME LIMITED WARRANTY 1. Defects Covered; Warranty Period: Pulse Shower Spas, Inc. (“Pulse”) warrants to the original consumer purchaser who purchases this shower spa (the “Product”) for use in his or her own home, that the Product will be free from defects in material and manufacturing workmanship for as long as the original consumer purchaser owns that same home.
