Installation Sheet

7
Usage
Pressure Balance Mixing Valve
The Navajo ShowerSpa is eqiuipped with a cUPC® pressure balance mixing valve to adjust water flow and
temperature. The valve automatically adjusts to changes in water pressure (i.e. someone flushes a toilet),
keeping your temerature constant and preventing accidental scalding. To turn on the ShowerSpa simply
raise the handle until the desired flow rate is achieved. Rotate to the right to decrease temperature and
rotate to the left to increase temperature. Be sure that the handle is in the OFF position when you are
done using your ShowerSpa so that pressure does not build up inside the unit.
Brass Diverter
The brass diverter is used to change between ShowerSpa functions. Simply rotate the diverter knob either
direction to select the desired function—shower head, hand shower or body jets.
Body Jets
The Navajo ShowerSpa is eqiuipped with four 3-function brass Infinity Jets™ with 3 spray patterns. The
angle of each jet can be adjusted by simply tilting the jet.
Hand Shower
The hand shower has three individual functions and two combo functions. Rotate the head of the hand
shower left or right to change between the power spray, pulsating massage or gentle cascade functions.
To adjust angle of hand shower, loosen ring on the hand shower holder, gently rotate toward you or the
wall, then tighten ring.
Care and Maintenance
Always blot dry any water from the surface of your ShowerSpa. To help protect your ShowerSpa
from hard water stains and mineral deposits, use an auto spray wax periodically and wipe down your
ShowerSpa after each use. Allowing water to evaporate on the surface can lead to a buildup of mineral
deposits. Cleaning with a damp, nonabrasive sponge and drying with a clean soft cloth should help keep
your ShowerSpa looking beautiful.
REMEMBER
NEVER use any abrasives or harsh cleaners!
Clean with mild soap and water ONLY!
To keep your ShowerSpa in pristine condition,
DRY AFTER EACH USE!