Installation Guide

7
Usage
Pressure Balance Mixing Valve
Brass Diverter
The Navajo Showerspa offers independent control of each function. Water pressure can be directed
to a single function or split between the different functions via the diverter knob. The three functions are
rain showerhead, hand shower and body jets.
Showerhead
The rain showerhead showerhead provides the relaxing feel of soft rain.
Hand Shower
The hand shower has a single power-spray pattern that can be used alone or in combination with any of
the other ShowerSpa functions.
Body Jets
There are four dual-head body jets. Twist the body jets to change the spray pattern.
Care and Maintenance
Always blot dry any water from the surface of your ShowerSpa. To help protect your ShowerSpa
from hard water stains and mineral deposits, use an auto spray wax periodically and wipe down your
ShowerSpa after each use. Allowing water to evaporate on the surface can lead to a buildup of mineral
deposits. Cleaning with a damp, nonabrasive sponge and drying with a clean soft cloth should help keep
your ShowerSpa looking beautiful.
REMEMBER
NEVER use any abrasives or harsh cleaners!
Clean with mild soap and water ONLY!
To keep your ShowerSpa in pristine condition,
DRY AFTER EACH USE!
The Navajo ShowerSpa is equipped with a cUPC® pressure balance mixing valve to adjust water flow and
temperature. The valve automatically adjusts to changes in water pressure (i.e. someone flushes a toilet),
keeping your temperature constant and preventing accidental scalding. To turn on the ShowerSpa simply raise
the handle until the desired flow rate is achieved. Rotate to the right to decrease temperature and rotate to the
left to increase temperature. Be sure that the handle is in the OFF position when you are done using your
ShowerSpa so that pressure does not build up inside the unit.