Installation Guide

7
Usage
Pressure Balance Mixing Valve
The Kihei II ShowerSpa is eqiuipped with a cUPC® pressure balance mixing valve to adjust water flow and tem-
perature. The valve automatically adjusts to changes in water pressure (i.e. someone flushes a toilet), keeping
your temerature constant and preventing accidental scalding. To turn on the ShowerSpa simply raise the handle
until the desired flow rate is achieved. Rotate to the right to decrease temperature and rotate to the left to
increase temperature. Be sure that the handle is in the OFF position when you are done using your ShowerSpa
so that pressure does not build up inside the unit.
Brass Diverter
The brass diverter is used to change between ShowerSpa functions. Simply rotate the diverter knob either direc-
tion to select the desired function—showerhead, hand shower, body jets or tub spout.
Body Jets
The Kihei II ShowerSpa comes with six dual-function body jets. Our new Select-A-Jet™ feature allows you to run
between two and six body jets at once. The top two jets are always on but the other four jets can be turned off
independently, increasing pressure to the remaining jets in use. The jets have both a power spray and fine mist
function. Simply rotate the face of the jet to select the different functions or turn them off.
Shower Arm
The shower arm on the Kihei II has a unique feature that allows you to change the height and angle of the
showerhead. The wingnut closest to the panel adjusts the height and the wingnut closest to the showerhead
adjusts the angle. Loosen one of the two wingnuts, reposition the showerhead and retighten the wingnut.
Hand Shower
The hand shower has three individual functions and two combo functions. Rotate the head of the hand shower
left or right to change between the power spray, pulsating massage or gentle cascade functions. To adjust angle
of hand shower gently rotate toward you or toward the wall. For vertical adjustment simply depress the button
and slide holder up or down.
Care and Maintenance
Always blot dry any water from the surface of your ShowerSpa. To protect your ShowerSpa from hard water
stains and mineral deposits, use an auto spray wax periodically and wipe down your ShowerSpa after each use.
Allowing water to evaporate on the surface can lead to a buildup of mineral deposits. Cleaning with a damp,
nonabrasive sponge and drying with a clean soft cloth should help keep your ShowerSpa looking beautiful.
REMEMBER
Never use any abrasives or harsh cleaners!
Clean with Mild Soap and Water ONLY!
To keep your ShowerSpa in pristine condition,
Dry after each use.